Official distributor in Russia and CIS countries
Mobile hydraulic test rig for high-pressure fittings testing
Needle valves, manifolds, shut-off valves and valve assemblies pressure testing
Model range of mobile units for hydraulic testing KGF-TEST M1 series
Mobile hydraulic installation KGS-TEST-M1-1800-230- L designed for hydraulic testing of high-pressure valves, needle valves, manifolds, shut-off valves and valve assemblies in the range of 700-1800 bar.
Installation composition:
- Hydraulic pump with pneumatic drive, model 5L-SD-230
- Power elements of the pneumatic pump drive:
- Through fitting for connection to the pneumatic network – mounting on the side panel
- Mechanical air filter-oil separator
- Pressure reducer – mounting on the control panel
- Start-stop/pump speed control valve – mounting on the control panel
- Low pressure line:
- Through fitting for connection to the water supply – mounting on the side panel
- Mechanical suction filter ½" 10 microns, 7 bar
- High pressure line:
- Mechanical pressure gauge on discharge: front flange for panel mounting, dial 160 mm, scale 0-2500 bar, accuracy class 1%, NPT fitting, measuring range (25-75%): 700-1800 bar
- Discharge fitting – mounting on the side panel
- Pressure relief valve without protection from mechanical contamination, outlet to the drain fitting
- High pressure tubes and fittings, pressure class not less than 4140 bar (60,000 PSI)
- Installation body: welded semi-open/closed stainless steel frame. steel with main control panel and side panels
- All controls and fittings are placed on the panel
- Intelligent design of control panels, signatures in Russian
| Pump Model | 5L-SD-230 |
| Number of pumps in the unit | 1 |
| Drive Type | pneumatic |
| Type of hydraulic part | single plunger |
| Type of pneumatic part | two-piston |
| Multiplication factor | 230 |
| Range of discharge operating pressures | 230 - 2379 bar |
| Maximum allowable pressure in the pneumatic network | 10.3 bar |
| Recommended pressure in the pneumatic network | 5 - 8 bar |
| Minimum pressure in the pneumatic network | 2 bar |
| Feed per cycle | 7.9 ml/cycle |
| Efficiency | 0 - 0.47 (1.7) l/min |
| Maximum permissible fluid pressure at the inlet fitting of the installation | 7 bar |
| Recommended fluid pressure at the inlet fitting of the installation | 3 bar |
| Minimum fluid pressure at the inlet fitting of the installation | 1 bar |
| Operating temperature range of the pneumatic actuator | -12 °C ... +65 °C |
| Operating temperature range of the hydraulic part | +3 °C ... +40 °C |
