Official distributor in Russia and CIS countries
Mobile test pack for tanks and vessels hydrostatic pressure tests
Hydrostatic pressure tests of reservoirs, tanks, vessels, steam-boilers, receivers, pressure chambers
Model range of mobile units for hydraulic testing KGF-TEST M1 series
Mobile installation KGS-TEST-M1-300-30- L for hydrostatic crimping of vessels, tanks, tanks and reservoirs, steam boilers, receivers, pressure chambers in the range of 100-300 bar.
The composition of the stand:
- Hydraulic pump with pneumatic drive, model 5L-SD-30
- Power elements of the pneumatic pump drive:
- Through fitting for connection to the pneumatic network – mounting on the side panel
- Mechanical air filter-oil separator
- Pressure reducer – mounting on the control panel
- Start-stop/pump speed control valve – mounting on the control panel
- Low pressure line:
- Through fitting for connection to the water supply – mounting on the side panel
- Mechanical suction filter ½" 10 microns, 7 bar
- High pressure line:
- Mechanical pressure gauge on discharge: front flange for panel mounting, dial 160 mm, scale 0-400 bar, accuracy class 1%, NPT fitting, measuring range (25-75%): 100-300 bar
- Discharge fitting – mounting on the side panel
- Pressure relief valve without protection from mechanical contamination, outlet to the drain fitting
- High pressure tubes and fittings – pressure class not less than 400 bar
- Installation body: welded semi-open/closed stainless steel frame. steel with main control panel and side panels
- All controls and fittings are placed on the panel
- Intelligent design of control panels, signatures in Russian
| Pump Model | 5L-SD-30 |
| Number of pumps in the unit | 1 |
| Drive Type | pneumatic |
| Type of hydraulic part | single plunger |
| Type of pneumatic part | two-piston |
| Multiplication factor | 30 |
| Range of discharge operating pressures | 30-310 bar |
| Maximum allowable pressure in the pneumatic network | 10.3 bar |
| Recommended pressure in the pneumatic network | 5-10 bar |
| Minimum pressure in the pneumatic network | 2 bar |
| Feed per cycle | 50.3 ml/cycle |
| Efficiency | 0 - 3.0 (10) l/min |
| Maximum permissible fluid pressure at the inlet fitting of the installation | 7 bar |
| Recommended fluid pressure at the inlet fitting of the installation | 3 bar |
| Minimum fluid pressure at the inlet fitting of the installation | atmospheric |
| Operating temperature range of the pneumatic actuator | -12 °C ... +65 °C |
| Operating temperature range of the hydraulic part | +3 °C ... +40 °C |
