Official distributor in Russia and CIS countries
Mobile unit for hydraulic testing of electric centrifugal pump equipment
For service of electric centrifugal pump equipment, leak testing of electric centrifugal pump submersible components
Model range of mobile units for hydraulic testing KGF-TEST M1 series
Mobile installation KGS-TEST-M1-450-45- M based on the HII pump model 5L-SS-45 for hydraulic testing of ESN equipment in the pressure range of 150-450 bar.
Installation composition:
- Hydraulic pump with pneumatic drive, model 5L-SS-45
- Power elements of the pneumatic pump drive:
- Through fitting for connection to the pneumatic network – mounting on the side panel
- Mechanical air filter-oil separator
- Pressure reducer – mounting on the control panel
- Start-stop/pump speed control valve – mounting on the control panel
- Low pressure line:
- Through fitting for connection to the water supply – mounting on the side panel
- Mechanical suction filter ½" 10 microns, 7 bar
- High pressure line:
- Mechanical pressure gauge on discharge: front flange for panel mounting, dial 160 mm, scale 0-600 bar, accuracy class 1%, NPT fitting, measuring range (25-75%): 150-450 bar
- Discharge fitting – mounting on the side panel
- Pressure relief valve without protection from mechanical contamination, outlet to the drain fitting
- 1/4" high pressure tubes and fittings – pressure class not less than 600 bar
- Installation body: welded semi-open/closed stainless steel frame. steel with main control panel and side panels
- All controls and fittings are placed on the panel
- Intelligent design of control panels, signatures in Russian
| Pump Model | 5L-SS-45 |
| Number of pumps in the unit | 1 |
| Drive Type | pneumatic |
| Type of hydraulic part | single plunger |
| Type of pneumatic part | single piston |
| Multiplication factor | 45 |
| Range of discharge operating pressures | 45-465 bar |
| Maximum allowable pressure in the pneumatic network | 10.3 bar |
| Recommended pressure in the pneumatic network | 5-10 bar |
| Minimum pressure in the pneumatic network | 2 bar |
| Feed per cycle | 20.3 ml/cycle |
| Efficiency | 0 - 1.2 (6.0) l/min |
| Maximum permissible fluid pressure at the inlet fitting of the installation | 7 bar |
| Recommended fluid pressure at the inlet fitting of the installation | 3 bar |
| Minimum fluid pressure at the inlet fitting of the installation | atmospheric |
| Operating temperature range of the pneumatic actuator | -12 °C ... +65 °C |
| Operating temperature range of the hydraulic part | +3 °C ... +40 °C |
